The Ford Barn - View Single Post

Karl · 10-27-2021, 04:15 AM

I have an old Myford Super 7 with a screw cutting gearbox and also a Myford Rodney Milling attachment as well as taper cutting attachment and dividing head etc . Its old but has been used little in its life .has been well looked after and works well - Its limitations are determined by the operator (ie me) rather than the lathe -its a very useful thing to have in the shop.

10-27-2021, 04:15 AM	#40
Karl Senior Member Join Date: May 2010 Location: Manawatu, New Zealand Posts: 1,416	Re: Lathe set up help for my shop I have an old Myford Super 7 with a screw cutting gearbox and also a Myford Rodney Milling attachment as well as taper cutting attachment and dividing head etc . Its old but has been used little in its life .has been well looked after and works well - Its limitations are determined by the operator (ie me) rather than the lathe -its a very useful thing to have in the shop. __________________ Such a fine sight to see-Its a Girl, My Lord, in a Flatbed Ford slowin' down to take a look at me.