The Ford Barn - View Single Post - Looking for some information on Badger grinding and Babbitt in Wi for 1934 ford block

35fordtn · 10-16-2020, 11:46 AM

Just a thought.. .030" Bearings will cost you a arm and a leg IF you find them. What I did last time, was pulled the crank, had the rod journals spray welded and ground back to Standard. It cost me $220 to have this done and I was able to use Standard sized bearings which are everywhere. Just a thought in case you can;t find any. We may have some .030 +.008" but I am not sure today

Follow Sheldon's advice and check eBay as well..

10-16-2020, 11:46 AM	#7
35fordtn Senior Member Join Date: Aug 2010 Location: McMinnville, TN Posts: 2,327	Re: Looking for some information on Badger grinding and Babbitt in Wi for 1934 ford b Just a thought.. .030" Bearings will cost you a arm and a leg IF you find them. What I did last time, was pulled the crank, had the rod journals spray welded and ground back to Standard. It cost me $220 to have this done and I was able to use Standard sized bearings which are everywhere. Just a thought in case you can;t find any. We may have some .030 +.008" but I am not sure today Follow Sheldon's advice and check eBay as well..