View Single Post
Old 09-08-2020, 05:04 AM   #1
russcc
Senior Member
 
Join Date: May 2010
Posts: 2,871
Default Cleaning an early aluminum intake

I would like to use an early intake on my test engine stand. It need a serious cleaning after years of sitting on the shelf. Any solutions I can put in to clean off the crud ? I could bead blast it but that's a lot of work for something that is just functional. Why are there 2 vacuum fittings between the 2 sets of intake ports. Any drawbacks to the early manifolds other than the 1" shorter fuel pump push rod ? Thank you Fordbarners.

Last edited by russcc; 02-22-2021 at 01:17 PM.
russcc is offline   Reply With Quote