Re: King Pins Anyone in MN that can do them
Now, there you go. The $8 reamer. One trick is not to lean too hard on the wrench while cranking, as not to egg shape the hole. Be genle, the tool drags in all by itself when turned. I covered to socket with one layer of self adhesive aluminum foil, to take the last few thou slop away. Works like a charm. In fact, I liked this setup more than the original tool with the pilots and the two sliding cones.
I did it not exactly for the fun of it, but beeing utterly sick and tired of asking around, I simply did it myself.
The bushings went out and in again with a large bench wise and a couple appropriate sockets as push Tools.
|