The Ford Barn - View Single Post

Kevin in NJ · 12-02-2021, 08:22 AM

Here are some charts to make life easy.

http://www.fordgarage.com/pages/jetflowrates.htm

I tested many jets using the Ford column length.

I did a lot of error checking and repeating and found the results were very consistant.

Most seemed to flow too much by a little to a lot and some were on the money. A few did not have a nice stream indicating there was a problem with the hole and flow.

12-02-2021, 08:22 AM	#3
Kevin in NJ Senior Member Join Date: May 2010 Location: South East NJ Posts: 3,398	Re: flow testing Model A Zenith carb jets Here are some charts to make life easy. http://www.fordgarage.com/pages/jetflowrates.htm I tested many jets using the Ford column length. I did a lot of error checking and repeating and found the results were very consistant. Most seemed to flow too much by a little to a lot and some were on the money. A few did not have a nice stream indicating there was a problem with the hole and flow.