Thread
:
Insert bearings
View Single Post
02-03-2017, 02:46 PM
#
45
Tom Wesenberg
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Re: Insert bearings
On the oil well on the right side, at the seam of the block and cap, does the bottom edge (cap edge) have a nice radius to allow the oil to get rolled into the clearance?
A sharp edge would be more likely to scrape away the oil.
Tom Wesenberg
View Public Profile
Send a private message to Tom Wesenberg
Find More Posts by Tom Wesenberg