View Single Post
Old 07-09-2020, 08:49 AM   #13
Mikko_
Member
 
Join Date: Mar 2019
Location: Sweden
Posts: 35
Default Re: Timing and hand throttle levers

Quote:
Originally Posted by Jack Shaft View Post
On top of all of the above,be sure and slide a piece of fuel line on the rods as an anti rattler.


Mikko,if your going to run a performance head get rid of the A distributor,go with a mechanical advance unit,the tolerance for timing inaccuracy gets shorter as you raise compression.I run the throttle rod only on mine..its handy for warm up and oklahoma cruise control..but I ditched the spark rod,run a B distributor.
Yes I will be running a high compression head and centrifugal advance distributor so I will probably ditch the spark lever too.
Mikko_ is offline   Reply With Quote