View Single Post
Old 07-08-2020, 11:11 AM   #23
asapguy
Senior Member
 
asapguy's Avatar
 
Join Date: May 2010
Location: Snohomish Wa.
Posts: 363
Default Re: Water in oil/engine

A couple things I didn't see mentioned. The 1st one could be related to the lose head nuts that were mentioned but if the distributer was removed & the head nut that holds the clamp for the dist, cable left off for any length of time water can run into the oil. Don't ask me how I know this!! 2nd thing is I no longer use the so called "modern gaskets". These gaskets have a steel reinforcement ring around the cyl. & can rust. On one of my cars with a B motor which has steam vent holes that an A motor doesn't have one of these gasket rusted from a steam vent hole to the cyl. allowing water into the oil. I tapped those steam vent holes with a metric allen screw & installed a copper gasket & never had a problem since.
asapguy is offline   Reply With Quote