The Ford Barn - View Single Post

Kurt in NJ · 07-03-2018, 07:54 PM

If the nut moves easy on the spindle you can't go wrong by tightening tight with wrench while rotating drum, back off then get as tight as you can with 2 fingers ---back off to nearest cotter pin place ----

07-03-2018, 07:54 PM	#5
Kurt in NJ Senior Member Join Date: May 2010 Location: on the Littlefield Posts: 6,159	Re: wheel bearings If the nut moves easy on the spindle you can't go wrong by tightening tight with wrench while rotating drum, back off then get as tight as you can with 2 fingers ---back off to nearest cotter pin place ----