The Ford Barn - View Single Post

Ol' Ron · 08-19-2018, 09:09 PM

The 33/34 "Camel back" Intake is a large casting, and can be hollowed out, The Bore can be increased to the size of the 2GC carb the carb can have a third bolt added where the PB port is filled with JB weld Noe it's a legule carb because it in the original place. The inside of the intake is formed with epoxy and fiber glass Then filled with foam to shape the runners. After the Epoxy hardens just pore some gas into the intake and lall the foam will melt away. I still have one of the last intakes I made. I;ll take some pics and try and post them. This was one mod that really worked quite well. It's nice when something work better than planned.

08-19-2018, 09:09 PM	#52
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,860	Re: Piston to head clearancing The 33/34 "Camel back" Intake is a large casting, and can be hollowed out, The Bore can be increased to the size of the 2GC carb the carb can have a third bolt added where the PB port is filled with JB weld Noe it's a legule carb because it in the original place. The inside of the intake is formed with epoxy and fiber glass Then filled with foam to shape the runners. After the Epoxy hardens just pore some gas into the intake and lall the foam will melt away. I still have one of the last intakes I made. I;ll take some pics and try and post them. This was one mod that really worked quite well. It's nice when something work better than planned.