The Ford Barn - View Single Post

Red Mark · 10-13-2014, 10:13 AM

I'm finally replacing a damaged rear axle and could use any advice in evaluating replacement candidate axles.

I've aquired six used axles as candidates for this project. Four of the six are better candidates with good end threads & keyways. All, however have some "grooving" where the grease seal bears on the shaft. Is this going to be an issue?

What else should I consider when evaluating a used axle? Thanks for any input.

10-13-2014, 10:13 AM	#1
Red Mark Junior Member Join Date: Jun 2011 Location: Michigan (Thumb area) Posts: 20	Evaluating rear axles I'm finally replacing a damaged rear axle and could use any advice in evaluating replacement candidate axles. I've aquired six used axles as candidates for this project. Four of the six are better candidates with good end threads & keyways. All, however have some "grooving" where the grease seal bears on the shaft. Is this going to be an issue? What else should I consider when evaluating a used axle? Thanks for any input.