The Ford Barn - View Single Post

Ken/Alabama · 07-20-2020, 12:55 PM

U joint goes on first. Then the one piece collar. Next the driveshaft gets inserted into the ujoint and slid up until the bell end of the torque tube mates up to the one piece collar. Then the two piece collar goes on last to hold it together. Make sure the cork strip is in the groove on the two piece collar and pack the ujoint cavity with grease before installing the one piece collar.

07-20-2020, 12:55 PM	#3
Ken/Alabama Senior Member Join Date: May 2010 Location: Alabama Posts: 3,258	Re: Trans install help U joint goes on first. Then the one piece collar. Next the driveshaft gets inserted into the ujoint and slid up until the bell end of the torque tube mates up to the one piece collar. Then the two piece collar goes on last to hold it together. Make sure the cork strip is in the groove on the two piece collar and pack the ujoint cavity with grease before installing the one piece collar.