[Step-down]

No history on the motor but I will take your advise and see if I can have someone check the Cam (max 1)
Cant put me finder on this build , someone spent a lot of money with all the machine work , soup to nuts but didn’t clean out the coolant system .
Everything is brand new inside with only a dusting inside the motor. I’ve done some quick numbers and everything looks good.
The motor was overheating (I’m told) so I pressure tested both sides and held 20 lbs over night .

Now the Cam either the cam wasn’t dialed in or it’s dead nuts on . I will know soon after it’s cleaned I’m going to mock it up .

I will post some more pictures tonight

Thank you everyone for taking the time to post