Re: Off shore adjustable lifters
Curious if the OP could put a couple "close-up" shots of the "tops" of the lifters where the valve stems reside? I have some used adjustable lifters here that are "telling me a story" so to speak!
I see a potential issue with the non "Johnson" tappets that may be causing many of the failures we're seeing, not 100% sure, but I see a definite "design-flaw" in the off-shore pieces! It was actually mentioned to me a while back by my friend Paul over at "Topline"!
Thanks, Gary in N.Y.
P.S. I'll have more on this subject if the OP can get that shot or two of the tops!
|