View Single Post
Old 10-06-2017, 03:13 PM   #23
Bob NH
Senior Member
 
Bob NH's Avatar
 
Join Date: May 2010
Location: Meredith, N.H.
Posts: 637
Default Re: oil sender removal tool

Todays update. I had to make a new temporary gas line in order to get the car to basement. Had three on the shelf but not correct on incoming pipe so had to turn down the crimped fittings from the old pipe in lathe in order to have stubs to attach hose with clamps. Poking around in my scrap steel, I found enough odd pieces of stuff and am now making a wrench somewhat like pictures you folks sent along . My success will tell the story if it works ! Just one hurdle after another I guess.
Bob NH is offline   Reply With Quote