01-16-2021, 09:46 AM
|
#13
|
Senior Member
Join Date: May 2010
Location: East Hartford, Ct
Posts: 5,898
|
Re: Anyone used Irontite block sealer in a Flathead?
Quote:
Originally Posted by Mr.C.
Thanks, I'll check on that lower front hole to see if it's there (the block is miles from my house). I'm using Irontite Ceramic Sealer. The engine wasn't leaking before re-build, but, the coolant had huge amounts of sealer in it, looked like K-seal or similar. The block is cracked above the pan rails, but we're going with it because a) it's free as I already have it, and b) it didn't use so much as a tea-spoon of coolant before.
While the block is clean and dry, I thought it a good idea to use the Irontite Ceramic sealer, then afterwards use their All Weather Sealer in the coolant. If that plan fails, I can chuck in loads of K-Seal like the previous owner did!
|
It now becomes clear as to why you are using the product that you selected.
__________________
DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES
|
|
|