Quote:
Originally Posted by Werner
Hi,
my new re-manufactured gear lever is too far to the left. That bothers me because my leg is leaning against the lever in gear # 1 and R.
Now I have read in a subtitle here in the forum that the re-manufactured gear levers have a slightly different angle geometry. I have now applied both levers exactly the same position and see a clear difference.
Has anyone experience with cold bending the lever at the bottom?
|
Werner-
There is a difference in the angle of the shift lever between 1928-29 models and 1930-31 models measured in a plane "from front to back". I think that is what I see in your photos. It is not a difference between original and reproduction shift levers. See the following page:
http://www.fordgarage.com/pages/tran...hiftlevers.htm
Wanting to bend the lever away from your leg is a common complaint. It requires heat, which ruins the plating on it. Attempts to bend cold often result in a broken shift lever.