The Ford Barn - View Single Post

Ol' Ron · 05-17-2014, 07:18 AM

Vergil
Excellent photo. I use a tilt table to machine the head, I also use a shell mille with a small radius on the tip to reduce the tendency to cause a crack at the machined edge. Gota start posting pics again.

05-17-2014, 07:18 AM	#14
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,860	Re: Need some head clearance advice Vergil Excellent photo. I use a tilt table to machine the head, I also use a shell mille with a small radius on the tip to reduce the tendency to cause a crack at the machined edge. Gota start posting pics again.