The Ford Barn - View Single Post

Ol' Ron · 05-16-2014, 07:21 PM

I would have the area over the valves milled at a 5 degree angle. this will on;y remove a small amount of material for valve clearance..

05-16-2014, 07:21 PM	#9
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,861	Re: Need some head clearance advice I would have the area over the valves milled at a 5 degree angle. this will on;y remove a small amount of material for valve clearance..