The Ford Barn - View Single Post

Al NJ · 03-05-2016, 01:20 PM

I have a broken temperature sending unit in a '39 cylinder head.
It's broken below the surface, nothing to put a wrench on.
Should I just drill it out with progressively larger bits until I can just peel out the remains?
I did a search but couldn't find anything. Any help would be appreciated.
Thanks.

03-05-2016, 01:20 PM	#1
Al NJ Member Join Date: May 2010 Location: New Jersey, The Garden State Posts: 98	Broken temp sender unit I have a broken temperature sending unit in a '39 cylinder head. It's broken below the surface, nothing to put a wrench on. Should I just drill it out with progressively larger bits until I can just peel out the remains? I did a search but couldn't find anything. Any help would be appreciated. Thanks.