The Ford Barn - View Single Post

Y-Blockhead · 08-02-2021, 06:18 PM

Can we assume that you are talking about removing the pinion assembly from the banjo and not removing the pinion from the drive shaft?

If so instead of removing the preload nuts I used a 1 1/8"split collar clamped to the drive shaft with the Mitchell Puller you have. Steve shipped me the puller with the O/D unit.

https://www.mcmaster.com/catalog/127/1344

08-02-2021, 06:18 PM	#5
Y-Blockhead Senior Member Join Date: Jul 2011 Location: Redondo Beach, CA Posts: 5,849	Re: Pinion Bearing Preload Can we assume that you are talking about removing the pinion assembly from the banjo and not removing the pinion from the drive shaft? If so instead of removing the preload nuts I used a 1 1/8"split collar clamped to the drive shaft with the Mitchell Puller you have. Steve shipped me the puller with the O/D unit. https://www.mcmaster.com/catalog/127/1344 Last edited by Y-Blockhead; 08-02-2021 at 06:24 PM.