Quote:
Originally Posted by bobj49f2
It turns over fine, it just didn't turn over when the heads were installed.
Another question, are there any differences between the EAB heads and the heads from a truck engine, 8HT(?)?. I'll need to find a either a matching head to two other kind that match.
|
OK i just reread your post, and you had a one or a couple of stuck pistons (or pistonring stuck to the cylinder).
Removing the heads was just a coincident.
I would remove the pistons and put in a new set of rings, think there is one or more piston with the rings stuck on them