Quote:
Originally Posted by 31Tudor
The welting starts about 2" past the rear of the splash apron and continues forward just wrapping over the front horns, but not below them. I have used contact cement, no problem. I have fit them first, marking and punching the holes in them, and then put the contact cement on and then put them on. You put webbing on the front body bolt pad with the two holes and also on the rear hood clamp pad.
|
Are you certain about this? On unmolested original cars I have disassembled, the anti-squeak was only under the apron and the front fender. No need to extend it 2" more inches.