View Single Post
Old 07-18-2016, 05:38 PM   #12
coupe1942
Senior Member
 
coupe1942's Avatar
 
Join Date: May 2016
Location: Ada, Oklahoma
Posts: 357
Default Re: Question on removal of ignition trim ring on instrument panel

Thanks for the insight as to how to correct it. I went to the advanced and edited it on all of my posts. I hope that straightens it all out. :-)

I am always intrigued by things such as owning my own pc unit as the one from HF. However, I am working hard to set up my garage and I am just not so sure there is any available space for an electric oven out there. The garage is in a mess right now, as I am trying to put things onto a table and sort them out before putting them away into organized shelf spaces or cabinets. It is a challenge and may not look like much is happening to make a dent in things, but slowly it is getting done. If I could just find a place for the oven, I may well go that route after all and pc the instrument panel.
coupe1942 is offline   Reply With Quote