The Ford Barn - View Single Post

Duffy1 · 07-26-2012, 09:00 PM

I do not think I have made any contradictory comments . If I have I apologize. The fact is I have a "B " engine with a model A dist and a model A timing gear cover validated by all the sites referenced above and various folks in both the model A clubs I belong to . I think the comment about the right parts and right procedures is the help I am looking for . Example ,Could the timing gear be installed a tooth out of phase with the crankshaft or could it be a repo timing gear not made to spec ,etc,etc.I was hoping some one out in the model A world might have the same problem and would come back with a response.

07-26-2012, 09:00 PM	#11
Duffy1 Senior Member Join Date: May 2012 Location: Mo. City , Texas Posts: 725	Re: 1938 "B" diamond engine I do not think I have made any contradictory comments . If I have I apologize. The fact is I have a "B " engine with a model A dist and a model A timing gear cover validated by all the sites referenced above and various folks in both the model A clubs I belong to . I think the comment about the right parts and right procedures is the help I am looking for . Example ,Could the timing gear be installed a tooth out of phase with the crankshaft or could it be a repo timing gear not made to spec ,etc,etc.I was hoping some one out in the model A world might have the same problem and would come back with a response.