[Y-Blockhead]

Originally Posted by kwisor

hello
i have looked at the info that is suggested. it was some help. i did not see any infor as to where the flat black nuts go also it looks like i am short one roller pin i sent a email to him . also the square pins i am still confused as to how to install them.
thank you

The four black flat nuts go on the adjustment screws on the backing plate. They hold the adjustment. Unlike the original adjusting wedge, the FHT floating wedge doesn't have the notches to hold the adjustment so you need the lock nuts.

Please study the Model A Times instructions closely, post #3.