Re: Wheel cylinder cleanup
I have wheel cylinder hones & dingle berry hones but I have a 6” long piece of 3/8 tubing with a slot cut I. One end. I take a sheet of red scotch brite cut it into 1 1/2 wide strip then slip one end into slot of tubing. I then twist it around tubing to make a hone cut it to length so the diameter fits cylinder & presto. Hone away for a great finish. Using drill of course with a liquid eg. solvent
Last edited by KiWinUS; 08-04-2020 at 06:15 AM.
|