View Single Post
Old 07-08-2020, 08:44 AM   #15
Jack Shaft
BANNED
 
Join Date: Dec 2019
Posts: 696
Default Re: Bending Overflow Tube

Seal closed the overflow tube,run a pressure type radiator cap with a relief type tube and neck..its pretty simple.The results are a different story,pressurizing raises the boiling point. On a model A raising the boiling point is moot,160 degrees being the optimum temperature.Like any repair,find the root cause of your issue,don't 'mask' it..fix the cooling system before you allow more heat capacity.
Jack Shaft is offline   Reply With Quote