View Single Post
Old 07-06-2020, 02:17 PM   #9
Ernie Vitucci
Senior Member
 
Join Date: May 2016
Location: Scottsdale, Arizona
Posts: 374
Default Re: Bending Overflow Tube

Good afternoon...What I did was to attach about four feet of rubber hose to the overflow tube and run it back to about where the wishbone ties in. I attached it with a bit of twisted wire every couple of feet and so any drip is under the middle of the car, in the dirt and it does not cause anything to rust...Ernie in Arizona
Ernie Vitucci is offline   Reply With Quote