Thread: Insert bearings
View Single Post
Old 07-05-2020, 11:38 AM   #60
Dave in MN
Senior Member
 
Dave in MN's Avatar
 
Join Date: May 2010
Location: Jordan, MN
Posts: 1,410
Default Re: Insert bearings

Synchro, Is it possible that the timing was a bit too far advanced for the load at times? It only takes a short run with too much advance to damage a bearing. Would you be able to share some photos of the insert shell? Thanks.

Last edited by Dave in MN; 07-05-2020 at 08:09 PM.
Dave in MN is offline   Reply With Quote