The Ford Barn - View Single Post - Interest in new restoration project thread?

deuce_roadster · 01-01-2020, 01:44 PM

Ralph, the spring ends are easier because it can open up as pressure is being applied. It is a whole different story on the rear axle housings and front end parts as Kube explained there is less room. I have the KRW tool and remember what a war it was before I got it. I don't think a C clamp frame is ridged enough for doing the hard (solid steel hole areas) the KRW tool is VERY stout.

01-01-2020, 01:44 PM	#180
deuce_roadster Senior Member Join Date: Oct 2011 Location: Shelton, WA Posts: 3,800	Re: Interest in new restoration project thread? Ralph, the spring ends are easier because it can open up as pressure is being applied. It is a whole different story on the rear axle housings and front end parts as Kube explained there is less room. I have the KRW tool and remember what a war it was before I got it. I don't think a C clamp frame is ridged enough for doing the hard (solid steel hole areas) the KRW tool is VERY stout.