View Single Post
Old 12-19-2019, 07:08 PM   #149
Kube
Senior Member
 
Kube's Avatar
 
Join Date: May 2010
Location: Wisconsin, USA
Posts: 6,247
Default Re: Interest in new restoration project thread?

Quote:
Originally Posted by deuce_roadster View Post
I have my torque tubes powder coated on the outside and since they have been sandblasted inside and out, I Glyptol the inside of the tube so it won't rust. It is really effortless to pull in the new center bearing with the KRW tool. I sight down and line up the arrow on the tool with the hole for the grease fitting, wipe a little liquid soap on the outer rubber donut and it slides in up to the stop very easily, dead on the grease hole in the T tube with the grease hole in the rubber donut.
Spoken by a man that (obviously) has the KRW tool
__________________
"I can explain it for you. However, I can't understand it for you".
Kube is offline   Reply With Quote