Thread: Manifold
View Single Post
Old 08-01-2020, 09:16 PM   #6
Mike Peters
Senior Member
 
Mike Peters's Avatar
 
Join Date: Aug 2012
Location: South East Wisconsin
Posts: 837
Default Re: Manifold

Sponsored Links (Register now to hide all advertisements)
I just did an exhaust/intake combo at our local machine shop. The owner was busy, so he told me to go ahead and do it myself. It's a flat table with a built in horizontal grinding wheel about 8" in diameter. You can run the wheel up and down to determine the amount of cut. I ran the manifold over that wheel a few times and it came out perfect. No more exhaust leaks. Only enough to clean it up.
Mike Peters is offline   Reply With Quote