The Ford Barn - View Single Post

JSeery · 06-27-2014, 12:10 PM

Worse case would be polishing or turning the crank to an undersize I would think. Last time I tried just changing bearings on a spun rod it lasted about two days! But then it wasn't a flathead. I depends on if any damage occurred to the crank or rod.

06-27-2014, 12:10 PM	#2
JSeery Member Emeritus Join Date: Nov 2012 Location: Wichita KS Posts: 16,132	Re: !939 spun #2 rod bearing Worse case would be polishing or turning the crank to an undersize I would think. Last time I tried just changing bearings on a spun rod it lasted about two days! But then it wasn't a flathead. I depends on if any damage occurred to the crank or rod.