View Single Post
Old 05-09-2010, 09:36 AM   #5
Roadster62
Senior Member
 
Roadster62's Avatar
 
Join Date: May 2010
Location: Ridgefield, Ct
Posts: 3,439
Default Re: Installing Model A Ford == D == Shaped Nuts

Thanks, I can picture that on a firewall or another area were a bucking bar will fit, but ther back rail is a boxed section. Bob
Quote:
Originally Posted by BRENT in 10-uh-C View Post
Part of the problem with welding them in, is some that are being sold today by the Model A vendors are actually made of brass, --which won't "weld" very well. The way we install them is to use a 2X rivet gun with a flush rivet set. Very clean and quick.
Roadster62 is offline   Reply With Quote