The Ford Barn - View Single Post

KiWinUS · 08-03-2020, 07:41 PM

I have wheel cylinder hones & dingle berry hones but I have a 6” long piece of 3/8 tubing with a slot cut I. One end. I take a sheet of red scotch brite cut it into 1 1/2 wide strip then slip one end into slot of tubing. I then twist it around tubing to make a hone cut it to length so the diameter fits cylinder & presto. Hone away for a great finish. Using drill of course with a liquid eg. solvent

08-03-2020, 07:41 PM	#4
KiWinUS Senior Member Join Date: May 2010 Location: Charlotte NC KiWi-L100 available here Posts: 2,953	Re: Wheel cylinder cleanup I have wheel cylinder hones & dingle berry hones but I have a 6” long piece of 3/8 tubing with a slot cut I. One end. I take a sheet of red scotch brite cut it into 1 1/2 wide strip then slip one end into slot of tubing. I then twist it around tubing to make a hone cut it to length so the diameter fits cylinder & presto. Hone away for a great finish. Using drill of course with a liquid eg. solvent Last edited by KiWinUS; 08-04-2020 at 06:15 AM.