Quote:
Originally Posted by aussie merc
well ive heard of it but never seen it. The marks on the screws are alignment marks and face upwards when the screws are bottomed out then a groove is cut to give a predetermined permanent opening [ie idle jet] this is used to keep fuel flowing in the carby and keep the bowl supply fresh so stopping secondary carbs fouling up with stale gas when not in use dont know if it works but thats the theory
|
Wow, that is some pretty cool hot rodding stuff. Never mind old school more like pre school. Sounds feasible to me. I would just stomp on the accelerator once in a while, more fun. Too bad I’m gonna run two primaries otherwise I would give it a try. Thanks Aussie Merc. How’re you fellas doing down under with this virus situation. People here are hording toilet paper. Whackos.