The Ford Barn - View Single Post - Dual Exhaust Manifold 49-51

Pat's 52 · 11-24-2014, 10:15 PM

In answer to your question I made the manifold. I copied it from a Douglass Header manifold. It is my understanding that the manifold was produced by the Douglass Foundry for the Ford Motor Co. The manifold was made available for 49-51 Ford police cars. I had the manifold reverse engineered and made the pattern to make the casting. Then had it machined.

I also reproduce the 52-54 manifold similar to the one that Ford offered. Lastly, I produce a manifold for the passenger side to give the appearance of factory dual exhaust.

11-24-2014, 10:15 PM	#3
Pat's 52 Member Join Date: May 2010 Posts: 64	Re: Dual Exhaust Manifold 49-51 In answer to your question I made the manifold. I copied it from a Douglass Header manifold. It is my understanding that the manifold was produced by the Douglass Foundry for the Ford Motor Co. The manifold was made available for 49-51 Ford police cars. I had the manifold reverse engineered and made the pattern to make the casting. Then had it machined. I also reproduce the 52-54 manifold similar to the one that Ford offered. Lastly, I produce a manifold for the passenger side to give the appearance of factory dual exhaust.