Quote:
Originally Posted by Robert/Texas
I bought a “Made in USA” light switch body and a “Made in ???” lighting harness from one of the vendors and tried to install them in my ’28 roadster today. After assembling them together I found that the switch mechanism was jammed.
I'm hoping that someone can help me with this problem.
Thanks in advance, Robert
|
Hey Robert,
Are you talking about the switch on the steering wheel being jammed?
If so take the wire harness and switch housing off the steering wheel, make sure the inside wire contact plate is lined up inside the housing (there is an alignment "key and slot") then make sure the horn/light switch "tabs" at the end of the steering wheel are positioned vertical or on Top and bottom not side to side.
Put the switch housing back the steering box (there is an alignment key and slot) and hopefully you can get it all aligned.
I just had this issue yesterday and had to take it all apart a few times to get it just right. Good Luck!!