Re: Drain plug
I wouldn't beat on the drain plug too hard .
Cast iron threads don't give like steel threads .
Replacing the transmission case isn't an easy job .
The back end would have to be removed first . .
I would use the pipe wrench .
If the handle of your wrench is too short , slip a longer pipe over the handle for added leverage .
Be careful not to jerk of knock the model A off of the stands while you are under it .
If heat is used , heat the case around the drain plug rather than the plug its self like Patric k L suggests .
If the plug is first heated , expansion from the heat can also cause the drain plug to expand and get tighter .
Last edited by Purdy Swoft; 10-23-2019 at 01:27 PM.
|