The Ford Barn - View Single Post

GB SISSON · 02-17-2020, 01:01 PM

Thanks Skip! I know that feeling.... 'Hmmm, I'll just shave a little off the side of this pulley on the lathe. More clearance is always good." Good thing I don't have a lathe. Anyone else want to chime in on 3/8" oil lines? And what do I use for hose? EFI fuel line? Hydraulic hose? Braided would be nice with some 90 degree tubular sweep fittings at the ends.

02-17-2020, 01:01 PM	#34
GB SISSON Senior Member Join Date: Jan 2014 Location: Orcas Island Washington Posts: 4,916	Re: What in Tarnation? Thanks Skip! I know that feeling.... 'Hmmm, I'll just shave a little off the side of this pulley on the lathe. More clearance is always good." Good thing I don't have a lathe. Anyone else want to chime in on 3/8" oil lines? And what do I use for hose? EFI fuel line? Hydraulic hose? Braided would be nice with some 90 degree tubular sweep fittings at the ends. __________________ Owner/Operator of 'Jailbar Ranch' on the side of Mt. Pickett. Current stable consists of 1946 1/2 ton pickup turned woodie wagon with FH V8, 1947 Tonner Pickup (red) mostly stock with exception of a cummins 6at turbo diesel, 1946 Tonner Pickup (green) with 226 cu in 6 cyl flathead, 1979 Toyota landcruiser wagon, completely encased in 1947 Ford Jailbar sheet metal. Ok, cornbinder rear fenders..... 'Rusty ol' floorboards, hot on their feet' (Alan Jackson)