Re: Tuesday tech. My lathe. Why is metric screwcutting screwy???
I'm confused how the imperial side still worked unless the ratio was dictated entirely by the distance between gears rather than the teeth. Which would mean there was a tiny difference in distance when switched to metric. Which there apparently isn't.
Curious.
__________________
<Link> This is how we roll<Link>
"I'm Convinced that no one really reads posts anymore; they just fabricate what they think the post says then ramble on about red herrings."--Bob
Outcasts rules of old cars
#1 Fun is imperative, mainstream is overrated
#2 If they think it is impossible, prove them wrong
#3 If the science says it impossible you are not being creative enough.
#4 No shame in recreating something you never had
#5 If it were not for the law & physics you would be unstoppable
|