The Ford Barn - View Single Post

ct · 02-21-2020, 01:51 AM

Thanks all for your responses.
Joe K Thanks for the tip re: the need for a radius. I planned to leave a small radius on the internal corner if "squared-off".

Brent I would love to use original bolts but they seem to be rarer than hens teeth. Re: "the specified length between the two 45° taper areas is listed as 29/64" (0.4531")". Mine are that measured between the large diameters of the two tapers

Steve Correct me if I'm wrong. You didn't shorten the bolts for the steel drums.
I thought that the shoulder might interfere with the lug nuts or nut spacer washers.

redmodelt Re: "the straight part is .220 between the two angles" so that must be for the shorter bolt for steel drums?

02-21-2020, 01:51 AM	#7
ct Junior Member Join Date: Jan 2012 Location: Queensland,Australia Posts: 10	Re: Rear hub bolts Thanks all for your responses. Joe K Thanks for the tip re: the need for a radius. I planned to leave a small radius on the internal corner if "squared-off". Brent I would love to use original bolts but they seem to be rarer than hens teeth. Re: "the specified length between the two 45° taper areas is listed as 29/64" (0.4531")". Mine are that measured between the large diameters of the two tapers Steve Correct me if I'm wrong. You didn't shorten the bolts for the steel drums. I thought that the shoulder might interfere with the lug nuts or nut spacer washers. redmodelt Re: "the straight part is .220 between the two angles" so that must be for the shorter bolt for steel drums?