Re: Manifold/Muffler Joint
I can't imagine that things are any different in the US from here but I use a muffler putty in there to get a good seal, as has been suggested above. It sets hard and to remove it, I use a wire brush in the drill.
BTW, the exhaust clamp is a #$%^ to install on a RHD car. It has to be just right or the clutch pedal won't go down past it. I put a helicoil in one side and use a shorter bolt which means there is no nut for the clutch pedal to hang up on.
__________________
I'm part of the only ever generation with an analogue childhood and a digital adulthood.
|