Quote:
Originally Posted by Ronnieroadster
The bar sits high enough to clear the stud, washer and nut assembly's holding the bearing cap to the block. To clear the studs holding the cap in place clearance holes are required in the bar.
Ronnieroadster
|
Oh I get it, the cap studs don't hold the bar, the bar is above and goes over top of the nuts. I assumed it would be all bolted together by the main studs/bolts. Nice.
I made cap supports sort of like that for 9" ford rears that fit in stock housings before aftermarket cases were plentiful, with through bolts and a flat machined on the cap and .001 squeeze fit.