View Single Post
Old 07-27-2020, 05:59 PM   #56
Senior Member
Yoyodyne's Avatar
Join Date: Nov 2010
Location: Lancaster PA
Posts: 372
Default Re: Let's build a drag race 8BA engine

Very clever setup, I wouldn't have thought of going through the pan with fasteners.
Do you modify the main cap for a seat for the bar, or just have it bear on the spotface areas for the main bolts? Where are the 5/16 bolts located and how are they used?
I'll never do this to a flathead, but I might be able to apply it elsewhere.

Thanks for the description!
Yoyodyne is offline   Reply With Quote