The Ford Barn - View Single Post

Tacoma Bob · 07-20-2020, 02:18 PM

Pluck, for what it's worth. When I had my motor,trans etc out of the car along with the front fenders removed I could lift the very ends of each frame rail up a good inch or two with one finger. the front end was off as well and my jack stands were just ahead of the motor mounts. These babies flex.

07-20-2020, 02:18 PM	#8
Tacoma Bob Senior Member Join Date: May 2010 Location: Tacoma, WA Posts: 1,025	Re: Frame to front and rear end alignment Pluck, for what it's worth. When I had my motor,trans etc out of the car along with the front fenders removed I could lift the very ends of each frame rail up a good inch or two with one finger. the front end was off as well and my jack stands were just ahead of the motor mounts. These babies flex.