View Single Post
Old 07-20-2020, 12:55 PM   #3
Ken/Alabama
Senior Member
 
Ken/Alabama's Avatar
 
Join Date: May 2010
Location: Alabama
Posts: 2,356
Default Re: Trans install help

U joint goes on first. Then the one piece collar. Next the driveshaft gets inserted into the ujoint and slid up until the bell end of the torque tube mates up to the one piece collar. Then the two piece collar goes on last to hold it together. Make sure the cork strip is in the groove on the two piece collar and pack the ujoint cavity with grease before installing the one piece collar.
Ken/Alabama is offline   Reply With Quote