View Single Post
Old 06-25-2020, 08:56 AM   #13
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 11,949
Default Re: My junkyard find

Hot rodders sometimes cut the spring perches off with the two top bolt flange ears intact. They will use them for bolt on spring mounts for AV8 conversions using the later Ford axles for more strength in the drive line. The set up has proven to work OK but very good quality bolts have to be used for the backing plates.

A person can make them adjustable for jack stands with a little pipe fabrication using heavy clevis pins with drilled holes at specific intervals. Most folks just don't do it since the Asian jack stands are so inexpensive.

Last edited by rotorwrench; 06-25-2020 at 09:01 AM.
rotorwrench is online now   Reply With Quote