Thread: master cylinder
View Single Post
Old 04-13-2020, 03:20 PM   #4
richard crow
Senior Member
 
Join Date: May 2010
Posts: 1,486
Default Re: master cylinder

i meet it all the time for some reason people think you have to tighten the cap very tight. most m.s are made of cast iron & the caps alum. now add brake fluid witch attracts mosture & six months later even king kong cant remove it. i have had to brake some caps remember to just make the cap snug. a little over hand tight if you use dot 5 you dont have this problem a lot of the replament m.c have plastic caps i guess they finely figred it out
richard crow is offline   Reply With Quote